Industry

I. Using Professional Measurement Tools 1. Electronic Level Measurement Place the electronic level on the platform surface and measure the height diff

1. Check printing dimensional accuracy If the printed model is approximately 1 mm smaller than the actual size in the X and Y directions, but all prop

I. Basic Equipment Calibration 1. Laser Power Calibration Measure the actual output power using a power meter and compare it with the set value. Adjus

I. Operation Procedure 1. Preparation Before Use Site Selection: Place the table on a flat, sturdy, and dry surface, leaving 1.5-2 meters of operating

1. Installation Preparation: First, adjust the bracket height to 800mm±5mm using a level. The embedded depth of the anchor bolts must be ≥20

I. Mechanical System Failures 1. Abnormal Positioning Accuracy Phenomenon: Workpiece repeatability deviation > 0.1mm Cause: Worn positioning pins,

1. Materials and Pretreatment Anti-corrosion treatment: Washers must be hot-dip galvanized according to GB/T18226 standard. After galvanizing, the thr

1. Welding equipment safety Power supply and grounding: The electric welder must be equipped with a leakage protection device. When connecting to the

1. Welding equipment maintenance Regular inspection: Regularly check the electrodes and welding heads of the spot welding machine to ensure that they

1. Daily cleaning and maintenance Keep the lock body clean Wipe the surface of the lock body with a soft dry cloth regularly to remove dust and dirt.

1. Regular inspection and tightening 1. Shorten the inspection cycle In a high vibration environment, the inspection frequency should be increased. It

1. Inspection before installation 1. Check product integrity Confirm that the band clamp has no defects such as cracks, deformation, and toothed belt